kfsone
Posts: 4
Joined: Sat Mar 09, 2019 2:04 pm

Show Infill width/height ratio in profile

Sat Mar 09, 2019 4:17 pm

While trying to tweak infill, there is a tiny bit of UI fail: there's a critical parameter (infill width/height) that is controlled by two or more other parameters, but is itself never actually shown to the user.
screen-the-first.jpg
First image
Getting this wrong has no effect until you try to print, at which point you are told it is wrong, but the value is still not revealed:
screen-the-second.jpg
second image
Suggested Fixes:
1- Please show the ratio on the appropriate tabs,
2- If possible: please highlight it when it's out of bounds,
3- If possible: please perform the validity check before letting me save/ok the profile.

Return to “Feature Requests”