wildvortex
Posts: 14
Joined: Thu Nov 08, 2018 5:13 pm

How to print a brim that skirts the part and not he supports

Sun Mar 31, 2019 3:17 pm

I have a part with a small footprint but very tall for it's width. All the way around this is supports. It is hollow on the underside/inside except supports. I don't want to use a raft as it was a bit difficult to remove. How do I print a brim that goes around the pieces edge not just around all the support edges. Cura will print the brim like this with the supports printed on top of the brim.

Return to “Feature Requests”