Page 1 of 1

Speed overrides in perimeters with small lenght

Posted: Sun Apr 21, 2019 3:47 pm
by zabana
Hi there!

I want to do a sugestion. In Speeds tab there is a box to be checked in Speed overrides. It only take consideration about the total layer printing time but is a good idea to add another one about perimeter lenght.

I mean if a perimeter is smaller than certain selectable lenght (for example in the eiffel tower) is a good idea to allow a speed reduction in the outter perimeter like as when the layer printing time is less than X secs. So for example if a perimeter is smaller than 5mm we can reduce the speed down to a X% of such normal perimeter speed.

Thanks a lot for reading my suggestion!