Page 1 of 1

Monoprice Delta Pro

Posted: Mon Jun 03, 2019 5:41 pm
by my67nova
Are there any special settings for an MP Delta Pro?

Re: Monoprice Delta Pro

Posted: Thu Aug 15, 2019 2:30 pm
by S3D-Jake
Please email our support team. They should be able to help you out with setting up your software environment for this printer.

Re: Monoprice Delta Pro

Posted: Tue Jan 21, 2020 3:56 pm
by nicholfd
Bump

If the support team would answer here, everyone wouldn't have to e-mail them directly...

What are the optimal settings for this printer?

Re: Monoprice Delta Pro

Posted: Sat Jan 25, 2020 9:05 pm
by S3D-Jake
nicholfd wrote:
Tue Jan 21, 2020 3:56 pm
Bump

If the support team would answer here, everyone wouldn't have to e-mail them directly...

What are the optimal settings for this printer?
I appreciate the idea! Our support team is comprised of engineers that are the most up to date on what settings to use with Simplify3D's supported printers. You're welcome to post their replies here, however the best way to get the most up to date information about supported printers will always be to contact our support team.

Re: Monoprice Delta Pro

Posted: Sun Jan 26, 2020 1:15 pm
by bander1023
nicholfd wrote:
Tue Jan 21, 2020 3:56 pm
Bump

If the support team would answer here, everyone wouldn't have to e-mail them directly...

What are the optimal settings for this printer?
Agreed completely. It doesn't matter if they're the most up-to-the-second settings or not. Give users a place to start. Maybe the support team gets lonely?

Anyway, I'm attaching my settings, which aren't too far off the Monoprice's suggestions (or Simplify's suggestions, either). Cheers!
Monoprice Delta Pro manual.fff
(12.39 KiB) Downloaded 120 times