Posts: 3
Joined: Sat Nov 25, 2017 12:53 pm

Multi processes by layer

Sun Jun 23, 2019 5:53 am

is it possible to set different processes by layer count and not by mm?

Posts: 90
Joined: Fri May 18, 2018 11:13 pm

Re: Multi processes by layer

Mon Jun 24, 2019 1:41 pm

Not that I'm aware of, but I would welcome this feature. The profile has the layer heights, so it should be an easy calculation.

Posts: 3
Joined: Fri Jul 05, 2019 9:15 pm

Re: Multi processes by layer

Fri Jul 05, 2019 9:21 pm

When creating multi-processes, I always have to do the math in order to verify if the milimeters translate to layer height so there's no gap between layers. PLEASE add a "layer height SNAP" to the program!

Posts: 7
Joined: Mon Aug 05, 2019 9:12 pm

Re: Multi processes by layer

Mon Aug 05, 2019 10:09 pm

I wholeheartedly support this. I use processes fairly liberally, and it's a PITA to have to do some math to figure out what to set as my start and stop heights. I typically decide on my process boundaries by clicking "prepare to print" and then stepping up and down through the 3D print preview, which steps by layer, not by height. I'm sure probably 99.9% of users who use multiple process decide on their process boundaries this way, by previewing the print by layer, so it's utterly absurd that S3D doesn't allow us to specify process boundaries by layer.

Return to “Feature Requests”