Page 2 of 2

Re: SLA Printing???

Posted: Wed Sep 02, 2020 8:43 pm
by TomOH
Support for the Anycubic Photon would be nice (actually even a reason to buy the long announced V5 if it was included in that release).

Re: SLA Printing???

Posted: Tue Oct 13, 2020 1:52 am
by Chappy1978
Same here I love Simplify3D but not supporting SLA printers like the Photon Mono is a real marketing mistake because there is plenty of free software out there that does. Maybe not a well as Simplify3d but it sends people away with a bad taste. When they want to fire off that SLA print and there is no support. Come on Simplify Team please make an SLA option.

SLA Printing

Posted: Sat Oct 17, 2020 9:35 pm
by DebraInore
I didnt want to inhibit postings that might improve the program But changing/augmenting the way already-calculated quantities are presented is in my perhaps doctrinaire view not a new feature. It is not achieving something that the program was not already capable of: it is a presentational change. A new feature would be, say, open-shell CC.

And I have to repeat my earlier comment: if someone can see that simply reassembling the final quantities and printing them differently is the need, isnt the best way to raise this just doing it, and then posting wouldnt it be better if this was done this way?, which is what the original poster seems to be already doing, based on his last post? And more power to him for doing it

Best regards
Pete

Re: SLA Printing???

Posted: Tue Oct 20, 2020 5:03 am
by prof5
i would also like to see the anycubic photon bring supported by ss3d