Page 1 of 1

NON PLANAR SLICING

Posted: Mon Sep 16, 2019 5:20 pm
by 1hander
i played around with this a while back.. and im sure it will have its challenges to implement, i think its where 3d printing should go...non planar slicing printing is a thing of beauty..

Re: NON PLANAR SLICING

Posted: Mon Sep 16, 2019 6:21 pm
by dkightley
Why not post on the existing thread on the subject: viewtopic.php?f=23&t=5814

Its the thread that S3D are watching to see what interest there is in the community!

Re: NON PLANAR SLICING

Posted: Tue Sep 17, 2019 9:28 am
by S3D-Jake
dkightley wrote: Why not post on the existing thread on the subject: viewtopic.php?f=23&t=5814

Its the thread that S3D are watching to see what interest there is in the community!
Thanks for looking out for our team here, Doug! That would certainly help us keep an eye on the requests the community is most interested in.
1hander wrote: i played around with this a while back.. and im sure it will have its challenges to implement, i think its where 3d printing should go...non planar slicing printing is a thing of beauty..
Would you happen to have any results you can share in the existing thread? (Pictures, or performance feedback, etc..)