Posts: 3
Joined: Mon May 18, 2020 8:55 am

Keep Factory Filename for save

Fri May 22, 2020 1:36 am

Allready existing factory file is saved with the name of the first objects name, instead of the opened filename.

Request: Save factory file with CTRL-S should allways use the same name as opened.

Posts: 753
Joined: Wed Jun 20, 2018 12:45 pm

Re: Keep Factory Filename for save

Wed May 27, 2020 2:08 pm

I believe this depends on how the factory file was opened. If it was automatically opened by the software (like in the case of you re-opening the software) the model's name is used. If you goto Load factory file, then the Ctrl + S option does save the factory file with the same name as the loaded factory file.
"A bird does not sing because it has an answer. It sings because it has a song."

Return to “Feature Requests”