Page 1 of 1

Estimated print time incorrect for Makerbot 5th gen

Posted: Mon Feb 22, 2021 12:07 am
by lith74
Estimated print time is severely inaccurate. The makerbot 5th gen shows the time left for the print the same as shown in the Simplify 3d software, however the percentage displayed on the printer is correct. On several prints the time is inaccurate., I had one print estimated at just under 20 hour and it took 26 hours to complete. Another estimated at 25 hours and finished in 33.

Re: Estimated print time incorrect for Makerbot 5th gen

Posted: Wed Feb 24, 2021 9:52 am
by zemlin