Page 2 of 2

Re: Modifier Mesh

Posted: Wed Jul 10, 2019 12:29 pm
by davoshaw
I just purchased S3d and wow I’m disappointed it doesn’t have this feature. I came from ideamaker and it has this feature.

Is this going to release soon??

Re: Modifier Mesh

Posted: Fri Jul 12, 2019 12:03 pm
by S3D-Jake
Davoshaw,

Thanks for your interest in this feature being added to the software. I've documented this feature previously. I will continue to monitor this thread for additional interest and input.

Re: Modifier Mesh

Posted: Wed Sep 11, 2019 9:02 pm
by JorgD
I can assure you there is massive interest in this feature. Being able to change infill parameters for parts of a model saves a lot of time and material on huge models on a Creality S5. Why infill the whole model at the densest requirement when only a small part needs dense infil? And sadly this part can not be separated by layer height.

Re: Modifier Mesh

Posted: Mon Sep 16, 2019 12:04 pm
by 1hander
i vote for this on too

Re: Modifier Mesh

Posted: Sun Sep 29, 2019 10:14 am
by dattrax
I'd like to vote for this as well. Slic3r isn't very good in other regards, so S3D is still my slicer of choice. I can't really do threaded inserts with S3D, as I need to change the number of perimeters for the entire part rather than just the places the inserts go.

Hopefully it'll make it into v5

Re: Modifier Mesh

Posted: Thu Dec 15, 2022 3:03 pm
by waterbornewarrio
Modifier mesh still needed!

Re: Modifier Mesh

Posted: Tue Jan 16, 2024 5:48 am
by cmadson
@Simplify3D 10 years later and we are still waiting....