JoeJ wrote:Just curious - what are some typical situations where you guys need to use this feature? I'm not sure I've ever had to mirror a model because either I designed it myself or I downloaded it from the thingiverse where most of them are already setup for 3D printing in the correct orientation. Just curious to hear some scenarios where this would be helpful
Downloading from thingieverse is a good example. Say you download a figurine that faces left, and you decide you'd like one that faces right also, so you can have one on each end of a shelf. With Repetier, you can click on the mirror icon, and its done. With S3d, you have to run it through a separate piece of software, and hope for the best.