Menissalt wrote:I agree. I have a heated glass bed and most things stick very well (very smoothly) once i use a brim but supports are proving (very) difficult. If we could just have the first couple of layers solid it would be a big help!
You can already do that by adding a raft, which prints a solid layer (depending on settings) under the part and support material. The problem I have with that is that I dont want the added layer of raft material sticking to the part and I only need where raft where the support material touches the bed.
I use a large skirt, that can trimmed off later, to hold the part to the bed.