Joules
Posts: 9
Joined: Wed Jul 01, 2015 3:34 pm

[DONE] Differing layer prints

Sun Jul 12, 2015 11:53 am

Hi, I have a question. Would it be possible at some point to print both 0.1mm and 0.2mm models on the same bed. Perhaps different colour models to represent the differing layer prints. I just thought printing every second layer for the 0.2mm objects or something along those lines.

Many Thanks for the V3.0 of Simplify3D.

Joules

BaudR8
Posts: 183
Joined: Fri Aug 29, 2014 9:59 am

Re: Differing layer prints

Mon Jul 13, 2015 6:02 am

This has always been available, make two processes, one using .1mm layer height and another using .2mm layer height. Then select the models you want for each process. Hit prepare to print and you will be prompted to select a process, choose to use both and in "continuous mode",


Joules
Posts: 9
Joined: Wed Jul 01, 2015 3:34 pm

Re: Differing layer prints

Mon Jul 13, 2015 4:36 pm

Many thanks, after I posted my question I NOTICED it was possible..... I am grateful for the tutorials though.

Return to “Feature Requests”