Re: Feature Request: Dynamic Extrusion Width/Gap Fill
Yes +1 The zig zag in thin walls is bad for the printer and your prints.
-
pipaev
- Posts: 22
- Joined: Thu Dec 24, 2015 7:17 am
- Location: Russia, Moscow, Zelenograd, skype: pipaev
Re: Feature Request: Dynamic Extrusion Width/Gap Fill
+1
P.S. Sorry for my English. Greetings from Russia!
-
Alex Borro
- Posts: 14
- Joined: Wed Jun 11, 2014 8:25 pm
Re: Feature Request: Dynamic Extrusion Width/Gap Fill
A great feature that S3D still lacks..
Cheers.
Alex.
Cheers.
Alex.
-
highground
- Posts: 7
- Joined: Mon Nov 30, 2015 6:11 am
-
highground
- Posts: 7
- Joined: Mon Nov 30, 2015 6:11 am
Re: Feature Request: Dynamic Extrusion Width/Gap Fill
3 pages of support for this request guys, can we at least get a comment? The free software can do it....
-
Joshb60796
- Posts: 3
- Joined: Sat Apr 16, 2016 5:29 pm
Re: Feature Request: Dynamic Extrusion Width/Gap Fill
+1! not to mention if you have wiping turned on, simplify3d wants to wipe in the zigzag pattern and it messes up the print quality drastically.
-
CompoundCarl
- Posts: 2005
- Joined: Wed Aug 05, 2015 7:23 am
Re: Feature Request: Dynamic Extrusion Width/Gap Fill
Just go to the Advanced tab an enable "Only wipe extruder for outer-most outlines". Then it only uses wiping on the outer-most perimeter and not on any of the zig-zag internal fill. Works fine for me.Joshb60796 wrote: if you have wiping turned on, simplify3d wants to wipe in the zigzag pattern and it messes up the print quality drastically.
