CCVirginia
Posts: 6
Joined: Sun Jul 19, 2015 12:59 pm

Explicit control of multiple surface types

Thu Aug 27, 2015 3:15 pm

This is a specific feature request as a follow-on to topic: viewtopic.php?f=9&t=3357

Simplify provides controls for various surfaces, such as top/bottom, infill, etc. However, there is insufficient and inconsistent control for all surface kinds. The request is to identify these surface kinds and have a consistent and complete set of controls for each. Surface types include:

Top, bottom on build plate, bridged bottom, supported bottom, top, exterior/exposed vertical surface, interior/exposed vertical surface, unexposed infill, support middle, support top, support bottom.

Potential controls for each include: speed, extrusion, fan, temp, pattern, angle, %fill, exterior layers, extruder, layer height/width and override for ooze control/filament retraction/head retraction (each can be default or override).

The horizontal/vertical distinction should be based on angle, like is used for supports.

The specific use case driving this is better "suspended layers" - either bridged or supported as shown in the topic referenced above. For example, I may want rectilinear slow for a supported bottom and concentric fast for the top. Even if all of the above is not possible now, better support for supported bottoms with infill is very much needed.

Return to “Feature Requests”