A support border to support the boundary of the solid layer
Posted: Wed Nov 11, 2015 10:03 am
I been having an issue with the supports generated by S3D.
Could it be possible that when generating the support, that within the support a border is printed the sits within the boundary of the solid support layer. so that the ends of the solid support layer can sit on it.
I was thinking to print it as part of the first layer and then every other layer there after.
it's been too often that I have had to print at a high support density because the solid support layer isn't supported and fails to do its job of SUPPORTING the part.
Could it be possible that when generating the support, that within the support a border is printed the sits within the boundary of the solid support layer. so that the ends of the solid support layer can sit on it.
I was thinking to print it as part of the first layer and then every other layer there after.
it's been too often that I have had to print at a high support density because the solid support layer isn't supported and fails to do its job of SUPPORTING the part.