mitchfx
Posts: 184
Joined: Fri Feb 27, 2015 6:01 pm

Raise3D N1/N2 support?

Fri Jan 22, 2016 6:42 am

Any plans to add configuration presets for the new printers from Raise3D? I believe they are marlin based so I hopefully doing my own settings won't be too difficult once my N2 plus arrives next month.

http://www.raise3d.com

CompoundCarl
Posts: 2005
Joined: Wed Aug 05, 2015 7:23 am

Re: Raise3D N1/N2 support?

Sat Jan 23, 2016 11:10 am

It should already be compatible, so you can use the configuration assistant wizard to set it up. It will guide you through the process.

makerjason
Posts: 1
Joined: Wed Feb 03, 2016 1:33 pm

Re: Raise3D N1/N2 support?

Wed Feb 24, 2016 6:53 am

Can I get a confirmation if simplify3d does support the N2 printers?
I checked out the supported Pinter's page, and it's not listed.

I'd like to order the unit, but I dont want to learn a new slicer.

CompoundCarl
Posts: 2005
Joined: Wed Aug 05, 2015 7:23 am

Re: Raise3D N1/N2 support?

Thu Feb 25, 2016 5:01 am

You are welcome to email the S3D support staff if you want an answer from them (contact form here: https://www.simplify3d.com/contact-us/).

But again, it uses the Marlin firmware, so it should be compatible. They most definitely already fully support Marlin printers (as I have several printers running the same firmware and they all work great)

Return to “Feature Requests”