Page 2 of 3

Re: Adjust print speed for overhangs

Posted: Wed May 17, 2017 5:26 pm
by Kldz
+1

Re: Adjust print speed for overhangs

Posted: Sat May 20, 2017 4:56 pm
by timpuri
+1

Re: Adjust print speed for overhangs

Posted: Wed May 24, 2017 1:41 pm
by fiekemike
+1
good idea, will greatly improve quality without increasing the printing time too much

Re: Adjust print speed for overhangs

Posted: Wed May 24, 2017 9:23 pm
by aubergine18
+1 for this

The workaround is somewhat cumbersome, I'd expect relatively expensive software to handle this sort of thing for me.

Re: Adjust print speed for overhangs

Posted: Mon May 29, 2017 11:38 am
by jrw
This feature is an absolute must for any slicer. It will improve the print immensely where it needs it the most, at no extra cost in terms of time or material, and is not very difficult to implement. I've attached an image showing how the print speed should look like for the Benchy model on the upper side arcs, where there will always be drooping material if not printed slow enough. As the overhangs get more pronounced, the print speed should gradually get slower.
SnapShot 102.png

Re: Adjust print speed for overhangs

Posted: Sat Sep 02, 2017 4:12 pm
by ieatacid
jrw wrote:This feature is an absolute must for any slicer. It will improve the print immensely where it needs it the most, at no extra cost in terms of time or material, and is not very difficult to implement. I've attached an image showing how the print speed should look like for the Benchy model on the upper side arcs, where there will always be drooping material if not printed slow enough. As the overhangs get more pronounced, the print speed should gradually get slower.
SnapShot 102.png
+1

This would be great to have, especially in the situation above, where using multiple processes either wouldn't work or would be extremely tedious.

Re: Adjust print speed for overhangs

Posted: Mon Apr 09, 2018 5:01 am
by pyrotech20
+1 (and bump)

Re: Adjust print speed for overhangs

Posted: Tue Apr 10, 2018 5:48 pm
by goldcd
+1
Not sure if it's reassuring or not to sign up to post an idea, and see I'm not alone in thinking this would be useful..

Re: Adjust print speed for overhangs

Posted: Wed Apr 11, 2018 5:30 am
by airscapes
+1

Re: Adjust print speed for overhangs

Posted: Sat Apr 14, 2018 9:15 am
by DiegoPear
+1