Manually setting a start point is great for placing seams "out of sight".
But what happens if you want to print multiple copies of that model?
It would be great if there were a solution to that!
This is quite an old thread, but I appreciate your added feedback. I'll track this thread to gauge additional user interest!armsofilum wrote: ↑Fri Jan 25, 2019 10:09 amI'm going to bump this up because I think it is an underappreciated request that could save people quite a lot of time.
I've recently come to S3D after being a Cura user for over 2 years and one of the features I miss from that application is the ability to set the Z-seam relative to each model. The suggestion by zemlin is a good one, but it doesn't help with complex models where the seam can be hidden in a less visible, inner portion of the piece.
This, and the ability to prioritize corners (either convex or concave), would vastly enhance what is already a great application and would give users much finer control over the seam placement without forcing separate processes for every piece on the build plate.