glx51mm
Posts: 27
Joined: Tue Jun 04, 2013 4:18 am

Coast at direction change

Mon Nov 25, 2013 1:39 pm

After trying to set my M2 for the best print quality I noticed that the amount of extruded plastic seems to increase at "steep" direction change, especially from 90 to 180 degrees. Actually, it is not the extrusion rate that is increased but is it a result of abrupt deceleration/acceleration. So, my question is, wouldn't it be better if there was an option to stop the extrusion just a bit before (a milimiter or less) reaching a sudden direction change ? Something like the coast option.
Let me all know of what you think.

Return to “Feature Requests”