Posts: 3
Joined: Mon Nov 26, 2018 4:15 pm

Re: [REQUEST] Smart startpoints for layer

Sat May 25, 2019 3:56 am

S3D-Jake wrote:
Thu Apr 04, 2019 1:33 pm
Thanks for the great ideas all around! I've forwarded this excellent feedback to our development team. I'll also stick around and monitor this thread for any other ideas about start point options.
sorry to necro this, but wanted to chime in. seam alignment has always been a little funky especially on complex geometries. +1

perhaps the ability to force the seam/retraction points on perimeters manually would be useful.

Posts: 4
Joined: Fri Jan 25, 2019 9:57 am

Re: Smart startpoints for layer

Fri Sep 20, 2019 9:30 am

I know I've posted this before, but since Jake asked for more start point suggestions I'll bring it back up.

Relative start points. I love being able to specify a coordinate close to where I want perimeters to start. However, when I add multiple parts to the build plate or need to move a part, the coordinates are fixed to a specific point on the bed. That makes setting up multi-part prints really time consuming. Cura gets this feature right with the ability to make seam placement relative to the midpoint of the model(s).

Posts: 646
Joined: Wed Jun 20, 2018 12:45 pm

Re: Smart startpoints for layer

Tue Sep 24, 2019 12:06 pm

Thanks again for the great feedback! I've added this to our list of suggested improvements for start points.
"A bird does not sing because it has an answer. It sings because it has a song."

Return to “Feature Requests”