tonyno
Posts: 164
Joined: Sat Jan 31, 2015 5:46 pm

Re: Ouside in, inside out, and desire "auto."

Mon Apr 06, 2015 9:58 pm

Whoa. Good necro! +1

ngen33r
Posts: 2
Joined: Thu Mar 02, 2017 10:25 am

Re: Ouside in, inside out, and desire "auto."

Thu Mar 02, 2017 10:28 am

Another +1 This is especially useful when using flexible filaments when support just wont work.

Like making a bellow from NinjaFlex

marjamar
Posts: 7
Joined: Sun May 15, 2016 12:41 am

Re: Ouside in, inside out, and desire "auto."

Sun Mar 05, 2017 2:50 pm

I made a request a few minutes ago that I think would add the lacking function to print angles better. I can print most angles fine if I turn outline to "0". Reason is, the outlines are printed before the infills and there are times where they print without anything under them and so they just fall. If there were a checkbox to tell simplify3D to print infills before outlines, most of the time there would be something for the outline to touch to and not fall off. Seems almost to simple and to intuitive and makes me wonder why I have to ask for this. It should always have been there to use one would think.

Here's my post it anyone would like to add their comments or "+1's".

viewtopic.php?f=23&t=7050

-Rodger

pyrotech20
Posts: 2
Joined: Mon Apr 09, 2018 4:58 am

Re: Ouside in, inside out, and desire "auto."

Tue Jul 30, 2019 5:56 pm

+1

I was going to post this request myself.. but found you beat me to it (by several years)

Return to “Feature Requests”