Something I really like about the Sli3er Prusa edition is that when I have a overhang the sli3er will put extra support the layer before it. This gives a better foundation and makes the lines of the overhang not drag over the support.
Just like all the other requests: it would be great to have this option, and if the variable layer height is also added in Simplify3D then I would never have to use the Prusa edition again.
I thank you in advance!
Re: More support just before an overhang
Do you mean just like using the Dense Support Layers on the Support tab of the profile settings??
That setting adds a higher density layer or layers in the support immediately under (and over, I think) any overhangs. You specify the number and density yourself!
That setting adds a higher density layer or layers in the support immediately under (and over, I think) any overhangs. You specify the number and density yourself!
Doug Kightley
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net
Re: More support just before an overhang
Yeah I saw it, I should have seen it before, excuse me for that. But variable layer height remains haha.
