axjurado
Posts: 2
Joined: Wed Aug 24, 2016 10:16 pm

Concentric bodies at different infills

Thu Aug 17, 2017 9:37 am

I have a large body to print. Logic says make it hollow to reduce time and material. But it doesn't work. Even though volume is much less the hollow creates more 100% infill surfaces and the weight is about the same as fully printed.

Tried making 2 concentric cubes and print one at much lower infill and cannot then one. You can print the internal at a much higher density but not the other way around.

So my request is to allow lower infills on interna volumes in order to reduce weight and print time.

Return to “Feature Requests”