It would be great if we could enable ironing that creates additional tool path above any area that doesn't have another layer directly on top of it. The tool path should be like external infill, but extend all the way to the edge of the outer perimeter.
Parameters to specify should be:
- Print Speed
- Density (controlling how many times the head goes over the same area so to speak)
- Offset angle from the layer below, defaulting to 90 degrees
- Fan Speed
- Retraction before ironing starts
- Possibly extrusion amount (not sure if it makes sense to put down material on this path)
I hope that makes sense, and I really hope Simplify3D will get that feature, I think there are many situations where this could be very helpful.