Posts: 9
Joined: Wed Oct 04, 2017 7:54 pm

Build Statistics per extruder

Wed Oct 04, 2017 8:18 pm


Is it possible to get Build Statistics per extruder?

When using dual extruder it would be extremely handy to know how much I will use of each indiviual material.

I try to keep my spool of PVA support material stored in a platic container with some silica gel packs to keep it from getting ruined by moisture in the air. So I try not to use the entire spool when I print, but to cut of a section I think I'll use. Now I always have to guess and am either wrong and have too little (bad!) or I'm wrong and I end up taking a much to large margin for error ;)

Return to “Feature Requests”