Network Printing

[Lord KiRon]

Network printing not supported ?
That's bad, I guess I will use this "two weeks money back" thing they offering. Because its inconvinient to use my Monoprice Voxel (Flashforge Adventurer 3 flashed) without a LAN.
I wish they had a demo version, this way I would avoid buying this software to start with.

[bobh1954]

Add me to the request for network printing to the Dremel Digilab 3D45 - I'd love to be able to do this from Simply3D

Thanks

Bob

[Miranda3D]

I would also very much like to be able to communicate directly with my printer from S3D. I have a Qidi X-Plus and currently I have to save the gcode from S3D then use the original Qidi control panel to move the file to the printer (defined by IP address) and tell it to 'Print'.

It works, but it's tedious, and to not have this facility is a very poor show for a piece of software that is (a) so highly recommended and (b) paid for.

Most of the time I'm not interested in sending commands directly to the printer, so for me, having a way to send the file to the printer then tell it to 'print' in one step from S3D would be sufficient.

Can you post an update on this request please? It seems it's been outstanding for years now.

[clafarge]

My FlashForge Adventurer 3 yearns to be found on the network. Oddly, you can only use the USB port when the Camera is disabled. I do think it simply makes sense to make use of the ubiquitous network access that the vast majority of people have in order to remove an unnecessary complication of this empowering tool.

Best,

Chad

[Stout]

I would also like to have a network/http-connection to my Duet Wifi but I guess that will never happen as this thread is a couple of years old and nothing new is happening?