Page 1 of 1

Network Printing

Posted: Sun Nov 05, 2017 2:24 pm
by shasselberg
Will it every be possible to print directly over the network to network-enabled printers, either WiFi or ethernet?

Re: Network Printing

Posted: Sun Aug 26, 2018 6:38 pm
by ddhawk
Add me to this request. Dremel 3D45 could use support for printing over WiFi.

Re: Network Printing

Posted: Mon May 06, 2019 10:55 pm
by argh
Make that 3 for Dremel 3D45.

I am so incredibly disappointed that the printer is "supported" but I can't use the wifi.

Re: Network Printing

Posted: Tue May 07, 2019 10:19 am
by S3D-Jake
Thanks for your feedback and suggestions. I believe the original intention of this thread from 2017 was to add network printing support in a more general sense. However I'll document your specific requests for 3D45 network printing support for our development team. In addition, I'll continue to monitor this thread for other network printing requests.

Re: Network Printing

Posted: Sun May 12, 2019 5:08 am
by markauskas
Support for Duet3D boards would be great as well.

Re: Network Printing

Posted: Mon May 13, 2019 2:01 pm
by S3D-Jake
Thanks for including the Duet3D Wifi / Ethernet as a mentioned printer board that supports network printing. Which revision of the board do you have? I'll add this to the feature request's documentation.

Re: Network Printing

Posted: Mon May 13, 2019 2:07 pm
by Ret
I second the support for network printing with Duet boards.

Re: Network Printing

Posted: Wed May 15, 2019 7:21 am
by hectorri
+1 to Duet3d Support.

Re: Network Printing

Posted: Wed May 15, 2019 12:47 pm
by markauskas
S3D-Jake wrote:
Mon May 13, 2019 2:01 pm
Thanks for including the Duet3D Wifi / Ethernet as a mentioned printer board that supports network printing. Which revision of the board do you have? I'll add this to the feature request's documentation.
I have a Duet 2 Wifi v1.03