Sat Oct 27, 2018 12:24 am
How does Simplify3D estimate print time without knowing the jerk and acceleration of the printers for which it is generating gcode? I notice S3D's print times are off significantly from the estimates sometimes. Is not knowing the jerk and acceleration the reason for this?
Also, please allow jerk and acceleration mod's for small perimeters. Slic3r has a setting for this that kicks in when a radius is less than 6.5 mm I believe.
Last edited by
inventabuild on Sat Oct 27, 2018 10:38 am, edited 1 time in total.