wbarber69 wrote: ↑
Sun Mar 11, 2018 11:10 am
SDX wrote: ↑
Tue Feb 27, 2018 12:09 pm
Linear Advance would be very difficult to implement within a slicer-software. It would at least double your g-code.
Craftware does it. quite well, and doesnt need the firmware to support it
you sure it's the same thing?
integrates with Simplify3D and allow you to
Calculate print time accurately (acceleration, max speed, junction deviation all taken into consideration)
Embed M117 codes into G-Code
Upload your G-Code directly to Octoprint
open source and unlicence