Nozzle strips at the print

[wext]

Hello,

unfotunately i have problems with S3D.
I have been printing with Cura longer and so far everything ran quite well,
now i bought S3D to have more Control over the printing Process.

The first layers are laid cleanly on the Heatbed and everything looks god,
when the print reach the height of 3-4mm the Nozzle beginns to strip.

I think the printer is not the problem because with cura i can print the same stl with no Problems.

My printer is a Prusa i3 Hephestos

I hope somebody can help me.

[brian442]

Did you read this already?
https://www.simplify3d.com/support/prin ... g-filament