BD22
Posts: 7
Joined: Sat Mar 09, 2019 5:43 pm

How to edit the eeprom?

Wed Jun 23, 2021 2:58 pm

If I want to change an eeprom setting, like the steps per feed, how can I do that with Simplify3D?

TheBum
Posts: 138
Joined: Fri May 18, 2018 11:13 pm

Re: How to edit the eeprom?

Wed Jun 23, 2021 6:03 pm

Look at the g-code definitions for the firmware your printer runs. This is my go-to reference for such things:

https://reprap.org/wiki/G-code

That said, it's a much better idea to make the change in your printer's configuration files.

Return to “General Discussion and Tips”