nadeemrehaan
Posts: 1
Joined: Mon Jun 04, 2018 2:49 pm

Cubepro Trio Level Calibration

Mon Jun 04, 2018 2:58 pm

Hi,

I have Cubepro trio 3d printer and I am looking for a solution on Level calibration ,
I sent so many emails to Cubepro support but they have only one answer "try to level your plate with 80gsm printing paper"
i tried this technique so many times but still same problem, when i start printing any object after printing surface the object start lifting from left side or sometimes right side and i used glue and double side tape but problem is same,

can anyone suggest me good way for Leveling plate.

thanks

Return to “General Discussion and Tips”