Hi guys, just bought the software the other day and am really impressed. I am using a Wanhao Duplicator 4x and typically using the dual extrusion features. There aren't a whole lot of things that Makerware does well, but I have had really good luck with their method for nozzle priming. Normally, with a 2x profile, it does 2 lines across the front of the build plate right at the edge. Right now, I have been using the Duplicator 4 profile in Simplify 3D and it doesn't actually prime the 2nd extruder. Also, I don't like the method of making a blob at the corner of the build plate because of potential for material sticking to the nozzle surface. Enough explanation... on to the real question.
I don't have a ton of experience editing gcode but have a pretty decent understanding of it. I have seen in the start script for the Duplicator 4 profile where it is priming etc. and could probably piddle around long enough to emulate the makerware priming routine, but was really hoping for a copy and paste solution. I loaded the 2x profile/ start script hoping it was like the makerware start script, but it was basically the same as the duplicator profile. This kind of makes sense because of the nearly identical architecture of the machines; however, I would really like that different priming routine. If I am just ignorant of a button or option, just point me in the right direction and I'll be on my way TIA