terry1956
Posts: 8
Joined: Tue Mar 28, 2017 2:48 pm

what am i doing wrong

Wed Aug 01, 2018 6:35 am

hi, I am trying to print a part on an ender 3 printer. its printed some nice parts but it just does not want to print this one. it starts ok but when it needs to start the infill it all goes wrong. I don't think its a table level problem as it printed the outer edge ok. its PLA filament and I have set the nozzle temp to 109 and the bed to 64. I have set the print speed to 1000 mm/s what am I doing wrong here. thanks for reading

IMG_1773.JPG[imgIMG_1773.JPG ][/img]

cairn
Posts: 15
Joined: Fri Oct 30, 2015 1:44 pm

Re: what am i doing wrong

Mon Aug 06, 2018 6:50 am

Srsly 1000 mm/sec? i've never tried above 100 mm/sec

SWCNT
Posts: 27
Joined: Mon Jul 16, 2018 9:51 am

Re: what am i doing wrong

Mon Aug 06, 2018 1:35 pm

Of the three numbers you gave us

Speed: 1000 mm/s
Nozzle Temp: 109 (assuming C)
Bed: 64 (assuming C)

Two of them make no sense.

S3D-Chris
Posts: 146
Joined: Wed Jun 20, 2018 12:52 pm

Re: what am i doing wrong

Mon Aug 06, 2018 3:20 pm

Hey Terry,

Try increasing the Extruder Temperature between 190-220°C and set the Bed Temperature between 45-60 °C. For more best practices for printing PLA filament we recommend checking out our Materials Guide: https://www.simplify3d.com/support/materials-guide/pla/.

As far as the Printing speed, try starting with the default of 2400mm/min.

Return to “General Discussion and Tips”