Can anyone tell me if there is a way to tell simplify to not wait for the heated bed to reach temperature before the extruder can start heating. all my other bits of slicer software just heat both at once.
Thanks
Matt
jimc wrote:normally i would never want the hotend sitting there cooking with plastic in it and not flowing. thats how the hot end starts to get tight and clog, however if you wanted to heat it up early wouldn't it be just as easy to just click the power on to the hot end in the machine control panel?
In the FFF Settings window, be sure the Advanced settings are exposed. In the Temperature tab, select the heated bed (in the list on the left). Then uncheck the box that says "[x] Wait for temperature controller to stabilize before beginning build".bigfella wrote:Can anyone tell me if there is a way to tell simplify to not wait for the heated bed to reach temperature before the extruder can start heating. all my other bits of slicer software just heat both at once.
Thanks
Matt