chrisbatih
Posts: 2
Joined: Wed Nov 07, 2018 9:32 am

New User

Wed Nov 07, 2018 9:36 am

Hi, I'm Chris.

I'm relatively new to 3D printing and have been using Simplify3D since I began with my Wanhao Duplicator I3 Mini a couple of months back. Just purchased my second printer (Creality CR-20), and as with printing in general, there's always more to learn.

Hope to increase my knowledge here.

Thanks.

S3D-Chris
Posts: 68
Joined: Wed Jun 20, 2018 11:52 am

Re: New User

Mon Dec 03, 2018 4:10 pm

Welcome to the Simplify3D Community Chris! We are confident you will learn a lot about Simplify3D and 3D printing on this forum! Also make sure to check out our free support resources here: https://www.simplify3d.com/support/

Return to “General Discussion and Tips”