New User

[chrisbatih]

Hi, I'm Chris.

I'm relatively new to 3D printing and have been using Simplify3D since I began with my Wanhao Duplicator I3 Mini a couple of months back. Just purchased my second printer (Creality CR-20), and as with printing in general, there's always more to learn.

Hope to increase my knowledge here.

Thanks.

[S3D-Chris]

Welcome to the Simplify3D Community Chris! We are confident you will learn a lot about Simplify3D and 3D printing on this forum! Also make sure to check out our free support resources here: https://www.simplify3d.com/support/