Page 1 of 1

New User

Posted: Wed Nov 07, 2018 9:36 am
by chrisbatih
Hi, I'm Chris.

I'm relatively new to 3D printing and have been using Simplify3D since I began with my Wanhao Duplicator I3 Mini a couple of months back. Just purchased my second printer (Creality CR-20), and as with printing in general, there's always more to learn.

Hope to increase my knowledge here.


Re: New User

Posted: Mon Dec 03, 2018 4:10 pm
by S3D-Chris
Welcome to the Simplify3D Community Chris! We are confident you will learn a lot about Simplify3D and 3D printing on this forum! Also make sure to check out our free support resources here: