I am at a bit of a loss here because I don't know what to do at this point. I have a creator pro and my bed is being wonky. (technical term of the day yes I know) I go through the bed leveling program provided on the creator pro cd card and I make sure there is a slight bit of friction between the bed and the nozzle using a piece of paper. Yet when I go to print (doesn't matter if I use simplify3d or flashprint) the bed is to low and the melted plastic won't stick. So, to me, it sounds like its machine related being it doesn't matter what program I use to print with. Does anyone have any ideas?