steve
Posts: 14
Joined: Wed Apr 24, 2013 4:19 pm

Bed Calibration

Tue Apr 30, 2013 5:19 pm

Hello Everyone,

I'm a complete noob to 3D printing and I'm trying to level the bed of my m2. I'm wondering what how much space I should leave between the hot end and the bed when its homed? I'm using tomlombardi's profile with a layer height of 0.25.

I'm assuming that incorrect calibration/distance from the hot end is the reason the front two corners of my prints keep curling by about 1-2mm.

Any help is appreciated.

sir-mike
Posts: 29
Joined: Mon Apr 15, 2013 5:53 pm

Re: Bed Calibration

Tue Apr 30, 2013 6:47 pm

The rule of thumb is the thikness of a you layer hight (0.25mm) in your case.
If yuo need more info see her: https://groups.google.com/forum/?fromgr ... Ow7dWWE3AJ

steve
Posts: 14
Joined: Wed Apr 24, 2013 4:19 pm

Re: Bed Calibration

Wed May 01, 2013 2:47 am

Thanks a million!

Return to “General Discussion and Tips”