pmf13
Posts: 1
Joined: Sat Jan 05, 2019 1:44 pm

Oversized model

Sat Jan 05, 2019 2:00 pm

If one of the dimensions of my model is larger than the print bed is there a tool in Simplify 3D that will break it down into printable "chunks" or do I need to do that in my design program before importing it to the slicer?

S3D-Chris
Posts: 125
Joined: Wed Jun 20, 2018 11:52 am

Re: Oversized model

Mon Jan 14, 2019 5:05 pm

The bottom of the virtual build plate can be used as a cutting tool. Anything positioned below it will not be printed. For anything more complicated than a planar cut, you should use your design software.

Return to “General Discussion and Tips”