Page 1 of 1

S3D and Kisslicer compare

Posted: Thu Jul 24, 2014 2:11 pm
by ta1dr
Hello All
I am S3D and Kisslicer user. I tried small part two slicer There are some differences I can not decide which was best to...

Image

Image

Image

and s3d profil files

http://www.ta1dr.com/slicer/40mm_sn_crank.zip

my printer Prusa i3 octave 1.75mm ABS flament

can you submit a comment...

I'm really undecided

Re: S3D and Kisslicer compare

Posted: Thu Jul 24, 2014 4:08 pm
by jimc
Settings from one slice dont necessarily transfer iver to other slicers. Default profiles in s3d are only a rough start point especially with your printer since there are so many differences. All thise blobs and overextrusion need yo ba taken care of. That can all be done with all the settings in the "retraction settings" section. Coast, restart, retraction, etc.