Page 1 of 1

Support Blocker?

Posted: Thu May 02, 2019 4:29 am
by quadcells
Hello,
Found this design on Thingiverse : https://www.thingiverse.com/thing:3597877/comments
The design speaks about using a support blocker.
Does Simplify3D supports 'Support Blocker'?
If so where do I find this option and how do I impalement it.
Thanks
/quadcells

Re: Support Blocker?

Posted: Thu May 02, 2019 8:16 am
by dkightley
S3D does not support "support blockers".

I would suggest using the manual support generation facility to define where you WANT supports.

Re: Support Blocker?

Posted: Thu May 02, 2019 8:29 am
by quadcells
Thanks for the reply.