Posts: 1
Joined: Fri Aug 30, 2019 6:17 am

Default baud rate?

Tue Sep 03, 2019 4:04 am

Having not used my Cocoon Create printer for a while, I recently blew the dust off and upgraded to S3D v4. When I open the Machine Control Panel the baud rate always defaults to 250000 so every time I have to change it for the printer to connect.

Now I'm not certain about this but I thought in previous versions of S3D there was an option to set the default baud rate so it was always correct and didn't have to be changed all the time. However I can't seem to find it in v4. Am I missing something?

Posts: 146
Joined: Wed Jun 20, 2018 12:52 pm

Re: Default baud rate?

Tue Sep 03, 2019 2:18 pm

You can change the default baud rate in the process settings: Gcode Tab > Update Firmware Configuration > Baud Rate

Return to “General Discussion and Tips”