Today I printed quite a large part, 10 hours worth and when I accidentally dropped it a small distance, the part snapped in 2 on a vertical pillar of cross section about 2cmx2cm. I couldnt believe it broke so easily but I know why. Here are some screenshots of the print preview and you can see what happened
Here is the part, normally
This is the layer just before the vertical column
and here it is above it
As you can see, the transition from infil into wall is immediate, this resulted in a massively weak part where the infil became a shell.
Now in makerware, it does this
where it prints a solid sheet below the transition from infil into the vertical wall
Meaning the wall is connected to solid plastic.
This is FAR stronger. I want to know, is there any settings in simplify3D where I can fix this? If not, maybe one could be implemented. I find it quite critical.