Snapmaker 2.0 (A350) ?

[deltasigma]

Hi,

I'm looking to buy the Snapmaker 2.0 version A350, but I would like to know if the S3D will be compatible?
Actually seem that the Snapmaker 1.0 is working.

Jean-Guy

[TheBum]

I use a profile for my Snapmaker 1.0 that I fully expect to work with the A350 after adjusting the bed size. I'm not sure about being able to print directly from S3D: I actually use an OctoPi as a network interface for my Snapmaker and just upload the G-code files to it and print from there. If the A350 supports raw sockets on its network interface, I would expect S3D to be able to print directly, but I'll still likely upload files to it so that I'm not reliant on the network connection to finish the job.

[S3D-Chris]

Hi,

I'm looking to buy the Snapmaker 2.0 version A350, but I would like to know if the S3D will be compatible?
Actually seem that the Snapmaker 1.0 is working.

Jean-Guy

Please contact our support team at support@simplify3d.com and we will help you with a profile.

[dharya]

Thanks for the information.

[DollArtbyJulie]

Will this be available soon?
I have a A250 and the Snapmaker software is awful!
Many people are receiving their Snapmaker 2.0 now, so a lot of people will want this

[adalta87]

I have my SM2 A350 and would love to have a Simplify3D profile for it, I do not much care for theirs and I honestly have only used simplify3d for ages now!

[rishabhlakhanpal]

HI did you manage to get a profile for Snapmaker 2 A350

[rpichet]

Where can we find the complete profile for snapmaker 2 different model (A350)?

[MrPointedHelix]

I'm also looking for a profile for the 350.