Printing Double Twist Vase Hollow?

[scampa]

How do I tell Simplify3D to make this vase hollow?

http://www.thingiverse.com/thing:37327

The default settings make it come up as a solid....

Thanks!!

[slipshine]

Set your bottom layers to 4
Set your top layers to 0
Set your infill to 0
Set your outside shells to 1 for very thin walls more for how thick you want it.

I have attached a sample .fff

NOTE I was working with ABS. If using pla change accordingly.

m2-vase-abs.fff

(2.43 KiB) Downloaded 233 times