Page 1 of 1

Printing Double Twist Vase Hollow?

Posted: Tue May 07, 2013 5:17 pm
by scampa
How do I tell Simplify3D to make this vase hollow?

http://www.thingiverse.com/thing:37327

The default settings make it come up as a solid....

Thanks!!

Re: Printing Double Twist Vase Hollow?

Posted: Tue May 07, 2013 10:55 pm
by slipshine
Set your bottom layers to 4
Set your top layers to 0
Set your infill to 0
Set your outside shells to 1 for very thin walls more for how thick you want it.

I have attached a sample .fff

NOTE I was working with ABS. If using pla change accordingly.
m2-vase-abs.fff
(2.43 KiB) Downloaded 238 times