Hello..
I have maybe a dumb question...
When i start a file the z always goes down to the table move to start point and prints..
But i prefer to first make the X/Y axis movement and then the Z movement,
because since the bed of the printer is not flat..
the corneers is higher then the rest of the bed, the nozzle touch lightly in the glass....
In the file gcode always start:
; tool H0.200 W0.400
G1 Z0.200 F1002
G1 X162.663 Y140.912 F6000
G1 E-0.2000 F3000
Is possible to have a command line or anything else to change the layer to:
; tool H0.200 W0.400
G1 X162.663 Y140.912 F6000
G1 Z0.200 F1002
G1 E-0.2000 F3000
Or i have to always edit the file and change the layer manually...?